Sauder 426930 - Step 7: Assemble Right Side Structure; Connect Right End Panel to Top, Bottom, Back Skirt; Install Short Braces to Upright and Right End

å
Fasten the RIGHT END (B). to the TOP (F), BOTTOM (G), and
BACK SKIRT (L). Use five 1-9/16" FLAT HEAD SCREWS (11).
å
NOTE: Be sure the WOOD DOWEL in the BACK SKIRT inserts
into the RIGHT END (B).
å
Fasten the SHORT BRACES (J) to the UPRIGHT (C) and
RIGHT END (B). Use eight 1-9/16" FLAT HEAD SCREWS (11).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
Step 7
G
L
B
C
J
J
F
Surface with
less holes
11
Unfinished edge
1-9/16" FLAT HEAD SCREW
(13 used in this step)
11
Page 11www.sauder.com/service426930