Sauder 426930 - Step 8: Install Back Panel; Fasten Back Panel and Follow Safety Caution

Step 8
å
Unfold the BACK (E) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (E).
Push on opposite corners of your unit if needed to make it
"square".
å
Fasten the BACK (E) to your unit using the NAILS (7). The
NAILS should be 4" apart and 1/4" in from the edges.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
8
4"
1/4"
G
B
E
F
A
NAIL
(62 used in this step)
7
Unfinished
surface
Page 12 www.sauder.com/service 426930