Sauder Carson Forge 412920 - Page 15

å
Carefully fl ip the UPRIGHT (D) over.
å
Fasten the EXTENSION BLOCK (Z) to the UPRIGHT (D).
Use two SILVER 2" FLAT HEAD SCREWS (57S).
å
Fasten one CABINET RIGHT (40CA) to the EXTENSION
BLOCK (Z) and one CABINET LEFT (40CB) to the
BRACE (I). Use four GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #3.
Step 10
Z
D
I
Angled edge
Roller end
1
2
3
4
1
2
3
4
SILVER 2" FLAT HEAD SCREW
(2 used for the EXTENSION BLOCK)
57S
Finished
surface
Page 15
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
3S
Roller end
Surface without
HIDDEN CAMS
The CAM SCREWS
must be here.