Sauder Transit 414417 - Step 6: Attach Desk Frames and Molding; Attach Desk Frames to Hutch Bottom; Molding Identification Note; Attach Upper Molding

Step 6
å
Carefully turn your unit over onto its back.
å
Fasten the DESK FRAMES (V) to the HUTCH BOTTOM (I).
Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: The UPPER MOLDING (X) will have more holes than
the LOWER MOLDING (Y). Do not confuse these MOLDINGS.
å
Fasten the UPPER MOLDING (X) to the HUTCH BOTTOM (I).
Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
414417 www.sauder.com/servicesPage 10
I
X
V
V
The UPPER MOLDING (X) will have more
holes than the LOWER MOLDING (Y).
Long edge
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
1S