å
Carefully turn your unit over onto its front edges. Lay the
HUTCH BACK (N) over your unit.
å
Make equal margins along all four edges of the HUTCH
BACK (N). Push on opposite corners of your unit if needed to
make it "square".
å
Fasten the HUTCH BACK (N) to your unit using the NAILS (1N).
Step 5
414417www.sauder.com/services
Page 9
N
NAIL
(28 used in this step)
1N
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
