Sauder Transit 414417 - Step 4: Attach Hutch Components; Fasten Hutch Uprights to Bottom; Initial Screw Tightening; Attach Hutch Bottom to Ends

Step 4
å
Fasten the HUTCH UPRIGHTS (E) to the HUTCH BOTTOM (I).
Use four BLACK 1-7/8" FLAT HEAD SCREWS (2S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Fasten the HUTCH BOTTOM (I) to the HUTCH ENDS (B). Use
four BLACK 1-7/8" FLAT HEAD SCREWS (2S).
414417 www.sauder.com/servicesPage 8
B
B
E
E
I
Surface with
more holes
Finished edge
Long fi nished edge
Finished edge
Edge with holes
BLACK 1-7/8" FLAT HEAD SCREW
(8 used in this step)
2S