INSTALLATION
Power supply • Make sure
the voltage is 230V.
Filling the DHW and heating circuit:
the switch to
Move
Open the automatic degasser
cap of the pump and all the caps of
the system bleeders.
Gas supply • Open
the cock • Check
the tightness of the
gas fittings.
right to bring up I.
Open the taps
located under
the boiler : cutting the screw
• Make sure that
the meter is suitable
for powering
all the user appliances at
the same time.
Open the blue filling tap located
under the boiler until you
read 0.8 bar on the pressure indicator.
must be in the direction of
flow.
26
1
4
3
2
Heating
flow
Note : for AS models, use the specific tap on the
system
Cold water inlet (model
AS excluded)
Heating
return
Goodwill
ÿ ÿ
ÿ
Machine Translated by Google
To Next Page
Loading...
