Savannah Heating BCF36

Questions and Answers

R
rangeldebbieAug 11, 2025
Why won't the pilot light on my Savannah Heating Indoor Fireplace light?
- Z
  zfoxAug 11, 2025
  If the pilot light won't ignite on your Savannah Heating Indoor Fireplace after pressing the piezo ignition button repeatedly, here are a few things to check: * **Check for spark:** Make sure the electrode is correctly aligned with a 1/8” (3mm) gap to the pilot hood. Reconnect any loose connections, or consider replacing the pilot assembly or piezo igniter. Tighten the mounting nut and/or igniter screws. * **Gas supply:** Ensure the shut-off valves are open, purge the gas lines, connect all gas lines properly, and inspect for any kinks in the gas line. The cause might be no gas or low gas pressure.
H
huangraymondAug 16, 2025
What to do if the pilot light won't stay lit on my Savannah Heating BCF36 Indoor Fireplace?
- B
  bconwayAug 17, 2025
  If the pilot light won't stay lit on your Savannah Heating Indoor Fireplace after following the lighting instructions, the issue might be related to the thermocouple or valve. Here's what you can do: * **Thermocouple/Valve Issues:** Adjust and clean the pilot, ensuring the flame impinges on or engulfs the thermocouple. Replace the thermocouple if needed. Ensure all wire connections at the gas valve terminals are tight and the thermocouple is fully inserted into the mounting bracket. Check wire continuity and connections in the pilot circuit. Check with your voltmeter. * **Defective Safety Circuit:** Check continuity, tighten wiring or connections, and repair if necessary.
S
spencertoddAug 22, 2025
How to fix a Savannah Heating BCF36 Indoor Fireplace when the main burner won't light?
- M
  Monique SolisAug 22, 2025
  If the main burner on your Savannah Heating Indoor Fireplace won't light, the problem might be with the valve or switches. Try turning the valve/switch to the 'ON' position. Also, check and clean the valve and switches. If that doesn't work, conduct a continuity test or jumper wire test and replace if defective, check batteries.
J
Jonathan SampsonAug 28, 2025
Why are the flames hitting the top of my Savannah Heating Indoor Fireplace?
- T
  Tara AustinAug 29, 2025
  If the flames in your Savannah Heating Indoor Fireplace are hitting the top of the firebox, it could be due to a restricted or inadequate vent system, or the manifold pressure being too high. Correct the flue as required and check the manifold pressure as required.
L
Laura SchneiderSep 3, 2025
Why does the flame on my Savannah Heating BCF36 burn blue and lift off the burner?
- L
  linda44Sep 4, 2025
  If the flame on your Savannah Heating Indoor Fireplace burns blue and lifts off the burner, it could be due to insufficient combustion air or the manifold pressure being set too high, or the vent system restricted. Make sure that nothing is blocking the air inlets and that the vent is adequate. Also, check the manifold pressure and the vent system.