To Next PageTo Next PageWhy is my Scag Power Equipment STTII-61V-37BV-EFI leaving a sloping ridge across the width of the cutting path?
A sloping ridge across the width of the cutting path can be caused by several factors: * Unequal tire pressures. Check and adjust tire pressure. * Uneven wheels. Check and adjust tire pressure. * Incorrectly mounted deck. See your authorized SCAG dealer. * Deck not level side-to-side. Check for level and correct.
How to fix streaking with my Scag Power Equipment Lawn Mower when there are strips of uncut grass between cutting paths?
If your Scag Power Equipment Lawn Mower is leaving strips of uncut grass between cutting paths, the issue is likely due to not enough overlapping between rows. Increase the overlap of each pass to resolve this.
What causes an uneven cut on uneven ground with my Scag Power Equipment Lawn Mower?
If you're experiencing an uneven cut (wavy appearance, high-low scalloped cut, or rough contour) while mowing on uneven ground with your Scag Power Equipment Lawn Mower, the primary cause is the uneven ground itself. To mitigate this, you may need to reduce ground speed, raise the cutting height, and/or change the direction of cut.
General| Model | STTII-61V-37BV-EFI |
|---|---|
| Category | Lawn Mower |
| Engine Power | 37 HP |
| Cutting Width | 61 inches |
| Fuel Capacity | 12 gallons |
| Type | Zero Turn Mower |
| Engine | Vanguard EFI |
| Engine Type | 4-Cycle, V-Twin |
| Drive System | Hydrostatic |
| Deck Type | Fabricated |
| Transmission | Hydrostatic |
| Turning Radius | Zero-turn |
| Speed | 12 mph |
Emphasizes operator responsibility and proper training for accident prevention.
Explains the meaning of DANGER, WARNING, and CAUTION signal words used in safety messages.
Crucial pre-operation checks, including hydraulic connections and operator instruction.
Guidelines for safe operation, including slope use, turns, and clearing obstructions.
Instructions and warnings related to the proper use and maintenance of the ROPS.
Step-by-step procedure for safely starting the mower engine, including pre-start checks.
Instructions on how to operate the mower's forward and reverse travel and steering controls.
Guides for adjusting cutter deck level, pitch, and height for optimal cutting performance.
A comprehensive chart detailing service procedures and their recommended intervals.
Instructions for checking and changing hydraulic oil and filter elements.
Outlines the warranty periods, coverage, exclusions, and terms for commercial equipment.
