SHC 2000
14
4.2. Switching on / Start - Stop
• Switching on:
Turn on the mains power switch (1).
L The unit performs a self-test. All segments of the 4-digit LED
temperature DISPLAY and all indicator lights will illuminate
(as illustrated on the left).
The display "OFF" indicates the unit is ready to operate
(standby mode).
Start:
• Press enter
for about 4 seconds.
The LED temperature DISPLAY indicates the actual bath
temperature.
Stop:
• Press enter
for about 4 seconds.
4.3. Setting the temperatures
Factory setting:
25 °C
L Setting can be carried out in the start/stop condition.
1. Press one of the keys for a short moment. The
setpoint value instead of the actual value is indicated on the
display for about 8 seconds. The value can now be changed.
2. Change value:
Press
to set a higher value.
Press
to set a lower value.
Keep the keys depressed for the value to change fast.
3. Press enter to store the value.
To Next Page
Loading...