SHC 2000
9.900.900.719 SHC2000-manual-111609 17
4.6. Timer function
With the timer function the operating time can be limited to an
allowed time.
4.6.1. Setting the time
L The setting can only be made in the Stop status.
1. Calling the timer function:
Hold the Enter key
pressed and activate the edit key
shortly. The time which was set last, is shown.
2. Setting the time:
Activate key
to set a higher value .
Activate key
to set a lower value .
Activate the key shortly for single step, hold the key pressed
for quick enumeration.
3. Store the set value with the Enter key .
Example: 120 minutes
Factory setting:
Max. time:
33 h 19 min.
L This time remains stored until something is changed.
4.6.2. Timer operation
• Starting the timer:
Hold the Enter key
pressed and activate the edit key
shortly.
L The bath temperature is shown. In case of timer operation the
comma in the display is blinking. The set time is counted up
to zero. When the time has elapsed, the circulator stops.
• Interrupting the timer / Failure of power supply voltage:
If there is a power failure, or if the unit is switched off at the
mains switch, the circulator memorizes the position of the
timer. When the power supply is switched on again, the
circulator only works off the remaining time.
• Canceling the timer operation:
Press the key
for approx. 4 seconds.
The timer can be restarted.
Timer operation
To Next Page
Loading...