INSTALLATION
MANUAL
© Scania CV AB 2017, Sweden
System overview
03:04 Issue 2.0 en-GB 7
Installation
1. Make a rectangular hole where the display is to be fitted (1). The hole should be
153 mm wide and 121 mm high. There must be at least 85 mm free space (A) be-
hind the display.
2. Position the display (2) in the hole.
3. Fit the mounting frame (3) with the accompanying screws.
The accompanying screws can be used if the thickness of the surface the display is
installed on (B) does not exceed 5 mm. Use the longer M3 screws for thicker surfac-
es.
If screws other than the accompanying screws are used, the length must be adjusted
so that the screws go no further than 12 mm in the display screw holes. If the screws
go in further, this may damage the electronics.
To Next Page
Loading...
