INSTALLATION
MANUAL
© Scania CV AB 2017, Sweden
System overview
03:04 Issue 2.0 en-GB 6
Positioning of the displays
Do not position the displays so that they are exposed to direct sunlight. This impairs
the readability of the displays. The user should have full access to the displays. It
must also be easy to access the connections on the rear of the displays.
The displays must not be fitted on vibrating equipment. They may only be positioned
next to the engine bed if either the engine or the display housing has vibration damp-
ing.
Main display
Scania recommends positioning the main display in the engine compartment for the
following reasons:
• To ensure that operation and monitoring are close to the engine.
• To minimise the lengths of the electrical cables between the sensors and main dis-
play.
• To reduce the risk of electrical interference caused by long electrical cables.
On a type approved installation, the main display must be located in the engine com-
partment.
Auxiliary display
The auxiliary display is normally positioned outside the engine compartment, but can
also be positioned in the engine compartment.
To Next Page
Loading...
