Scansonic DA310 - General Operation; Powering On and Off; Mode Selection Guide; Volume and Mute Control

11
General operation
powering ON/OFF
Whenyourstconnecttheunittothemainssocket,displaywillshowthe
“Scan Time 00:00:00” and synchronize to the current local time if you can
receive a DAB signal in your lopcation. After approximate one minute, it will
switch to STANDBY mode.
• Press⏻ on the unit or press ON/STAND-By on the remote control to
switch the unit to ON mode.
• Press ⏻ to switch the unit back to STANDBY mode.
• Disconnect the mains plug from the mains socket if you want to switch
the unit off completeley.
Selecting modes
Press MODE repeatedly on the unit or press CD, USB, TUNER/DAB,
AUDIO IN, BLUETOOTH on the remote to switch between DAB, FM, CD,
USB, AUX and Bluetooth modes.
Adjusting the volume
• Turn the VOLUME +/– dial on the unit or press VOL +/– on the remote
control to adjust the volume.
• If you wish to turn the sound off, press MUTE on the remote control.
Press MUTE again or press VOL +/– on the remote control or turn VOL-
UME +/– to resume normal listening.
Auto setting the clock
The clock can be updated automatically if you can receive a DAB signal
in your location. In order to synchronise to the current local time you must
leave it on the DAB station for a short period of time.
Manually setting the time
1. During Standby mode, press and hold CLOCK on the remote control.
Thehourdigitsashonthedisplay.
2. Press I◄◄ I ►► to adjust the hour digits, and then press CLOCK to
conrm.Theminutedigitswillashonthedisplay.
3. Press I◄◄ I ►► to adjust the minute digits, and then press CLOCK to
conrm.
4. The time is now set.
general operation
powering ON/OFF
Scan Time
00:00:00” and synchronize to the current local time if you can receive a DAB signal in your
location. After approximate one minute, it will switch to STANDBY mode.
t Press on the unit or press ON/STAND-BY on the remote control to switch the unit to
ON mode.
t Press to switch the unit back to STANDBY mode.
t
completely.
t When the unit is idle for approximately 15 minutes, it will automatically switch to standby.
t
selecting modes
Press MODE repeatedly to switch between DAB, FM, CD, USB, AUX and Bluetooth modes.
adjusting the volume
t Turn the VOLUME +/– dial on the unit or press VOLUME +/– on the remote control to
adjust the volume.
t
MUTE on the remote control. Press MUTE again
or press VOLUME +/– on the remote control or turn VOLUME +/– to resume normal
listening.
auto setting the clock
The clock can be updated automatically if you can receive a DAB signal in your location.
In order to synchronise to the current local time you must leave it on the DAB station for a
short period of time.
manually setting the time
1. During Standby mode, press and hold CLOCK on the remote control. The hour digits
2. Press to adjust the hour digits, and then press CLOCK
3. Press to adjust the minute digits, and then press CLOCK
4. The time is now set.
15
MODE repeatedly on the unit or press
CD, USB, TUNER/DAB, AUDIO IN,
BLUETOOTH on the remote
• When the unit is idle for approximately 15 minutes, it will
automatically switch to standby.
• Please turn the unit off completely to save when not in use.