Table of Contents
General safety instructions for Power Tools………………….………….1-4
Main specification……………………………………………………………...5
Unpacking and checking contents…………………………………………5
List of loose parts in the box and bags……………………………………6
Getting to know your drill press…………………………………………….7
Assembly………………………………………………………………………..8
Lubrication……………………………………………………………………...9
Maintenance……………………………………………………………………9
Wire diagram…………………………………………………………………...9-10
Trouble shooting……………………………………………………………...11
Repair parts……………………………………………………………………12-16
Warranty………………………………………………………………………..17
General safety instructions for Power Tools
1: KNOW YOUR POWER TOOL
Read and understand the owner’s manual and labels affixed to the tool. Learn
its application and
limitations as well as the specific potential hazards peculiar
to this tool.
2. GROUND ALL TOOLS
This tool is equipped with an approved 3 conductor and a 3 prong grounding
type plug to fit the proper grounding type receptacle.
3. KEEP GUARDS IN PLACE
In working order and in proper adjustment and alignment.
4. WEAR PROPER APPAREL
Do not wear loose clothing,gloves,neckties,or jewelry (rings,wrist,watches) to
get caught in moving parts. Wear protective hair covering to contain long hair.
Roll long sleeves above the elbow.
5. USE SAFETY GOGGLES
6. KEEP WORK AREA CLEAN
Cluttered areas and benches invite accidents. Floor must not be slippery due to
wax or sawdust.
7. KEEP CHILDREN AWAY
.1.
To Next Page
Loading...
