Why is my Scantool Power Tool drill bit burning?
Your Scantool Power Tool drill bit may be burning due to several reasons: * The speed might be incorrect, so try changing it. * Chips may not be coming out of the hole; retract the drill bit frequently to clear them. * The drill bit could be dull, requiring resharpening. * The feeding speed may be too slow, so increase it. * The drill bit may not be lubricated, so apply lubrication.
What to do if my Scantool 16AE Power Tool is making a lot of noise?
If your Scantool Power Tool is operating noisily, consider the following: * The belt tension might be incorrect, so adjust it. * The spindle might be dry, requiring lubrication. * The spindle pulley could be loose; check the tightness of the retaining nut on the pulley and tighten if necessary. * The motor pulley may be loose; tighten the setscrews in the pulleys.
Why does my Scantool 16AE Power Tool drill bit have excessive run out or wobble?
Excessive drill bit run out or wobble in your Scantool Power Tool can be caused by: * A bent drill bit; use a straight drill bit. * Worn spindle bearings; replace the bearings. * The drill bit not being properly installed in the chuck; install the drill bit properly. * The chuck not being properly installed; install the chuck properly.
What to do if Scantool Power Tool drill bit leads off or the hole is not round?
If your Scantool Power Tool drill bit leads off or the hole isn't round, it could be due to: * Hard grain in the wood or unequal lengths/angles of the cutting lips; resharpen the drill bit correctly. * A bent drill bit; replace the drill bit.
What to do if my Scantool Power Tool drill bit binds in the workpiece?
If the drill bit binds in the workpiece when using your Scantool Power Tool, it may be due to: * The workpiece pinching the drill bit or excessive feed pressure; support or clamp the workpiece. * Improper belt tension; adjust the tension.
What to do if wood splinters on the underside when using my Scantool Power Tool?
If wood splinters on the underside when using your Scantool Power Tool, it's likely because there is no "back up material" under the workpiece. Use "back-up material".
What to do if the workpiece turns loose from my hand while using Scantool 16AE Power Tool?
If the workpiece turns loose from your hand while using the Scantool Power Tool, it is because it is not supported or clamped properly. Support the working piece or clamp it.
Why does the chuck of my Scantool 16AE not stay attached to the spindle?
If the chuck of your Scantool Power Tool does not stay attached to the spindle, it could be due to dirt, grease, or oil on the tapered inside surface of the chuck or on the spindle's tapered surface. Clean the tapered surfaces of the chuck and spindle with a household detergent to remove all dirt, grease, and oil.
Why does the quill of my Scantool 16AE return too slow or too fast?
If the quill of your Scantool Power Tool returns too slowly or too fast, it indicates that the spring has improper tension. Adjust the spring tension.
General| Brand | Scantool |
|---|---|
| Model | 16AE |
| Category | Power Tool |
| Language | English |
To Next Page
