Why is my Sceptre E325 picture is very dim?
If your Sceptre HDTV picture is very dim, check if you are in POWER SAVING mode. Keep pressing the PICTURE button on the remote control to cycle out of POWER SAVING.
Why Sceptre HDTV cannot receive sufficient channels through the ATSC/NTSC tuner?
If your Sceptre HDTV cannot receive enough channels through the ATSC/NTSC tuner, it may be due to a weak signal. Change the direction of your antenna and rescan your channels. If you have cable, contact your cable company to inquire about the signal strength of your local cable.
What to do if Sceptre E325 remote control does not work?
If your Sceptre HDTV remote control isn't working, turn off the TV and unplug it. Remove the batteries from the remote for 30 minutes, then press the remote buttons and the power button randomly for 2 seconds before reinstalling the batteries. Also, ensure there is a clear line of sight between the remote control's front sensor and the TV's remote sensor.
Why does my Sceptre E325 have picture only but no audio?
If your Sceptre HDTV shows a picture but has no audio, first ensure the audio cable is properly connected. Then, readjust the volume using the remote control. Also, make sure that the TV’s tuner signal is not lower than 65 %.
Why does my Sceptre E325 HDTV have audio only but no picture?
If your Sceptre HDTV has audio but no picture, verify that both your video and audio cables are securely connected. Also, ensure the TV’s tuner signal is not lower than 65 %.
How to remove big black box in the middle of Sceptre HDTV screen?
The big black box in the middle of your Sceptre HDTV screen indicates that closed captioning is turned on and set to TEXT1 – TEXT4. Change the setting to CC1 or turn off closed captioning to remove the box.
What to do about pixels that are always displaying the same color on Sceptre E325?
Pixel defects within industry specifications are inherent to this type of product and do not constitute a defective product.
Why I cannot change the time manually on Sceptre E325?
Your Sceptre TV syncs time automatically according to your local TV channel.
How to fix Sceptre E325 HDCP video says no HDCP support?
To resolve the 'No HDCP Support' message on your Sceptre HDTV, reboot your HDCP video device by turning it off and unplugging the power cord.
How to fix weak signal or no program symbol on Sceptre E325 HDTV screen?
If you see a weak signal or no program symbol on your Sceptre HDTV screen, try changing the direction of your antenna and rescanning the channels. If you have cable, contact your cable provider to inquire about the signal strength of your local cable.
Steps for protecting the TV during storms or extended periods of non-use.
Connect antenna/cable directly to TV.
Initial steps for powering on and connecting devices.
Initial setup for antenna/cable without box.
Using remote buttons for OSD navigation.
Using side buttons for OSD navigation.
Adjusts picture settings like contrast, brightness.
Adjusts audio settings like bass, treble.
Manages tuner functions like scanning and editing.
General| Screen Size | 32 inches |
|---|---|
| Display Type | LED |
| Aspect Ratio | 16:9 |
| Refresh Rate | 60Hz |
| USB Ports | 1 |
| Built-in Speakers | Yes |
| Resolution | 1920 x 1080 |
| Inputs | HDMI, Component Video, Composite Video |
| Audio Output | 3.5mm headphone jack |
To Next Page
