SCEPTRE X46 HDTV User Manual
- 35 -
www.SCEPTRE.com
If You Want the Fair Connection
with S-Video…
1. Make sure the power of X46 LCD HDTV and your set-top box is
turned off.
2. Obtain an S-Video Cable. Connect the S-Video connector to both
your set-top box and AV 1’s S-Video connector port off the back of
your X46 LCD HDTV.
3. Obtain a RCA Audio Cable. Connect the white color connector to
both your set-top box and AV 1’s white connector port off the back of
your X46 LCD HDTV.
4. Connect the red color connector to both your set-top box and AV 1’s
red connector port off the back of your X46 LCD HDTV.
5. Turn on the X46 LCD HDTV and your set-top box.
6. Use the remote control’s source button or the source button on the
right side of the TV to switch to AV 1 (S-Video).
Please Note :
• If AV 1 is already occupied, please use AV 2 as your connection port and switch
source to AV 2 (S-Video).
• Please reference the set-top box’s manual as well, to make sure the set-top box
is configured to output correctly to the TV.
• AV 2 is located on the left side of the TV, while facing the front of the TV.
• Sceptre’s X46 LCD HDTV supports SONY’s universal remote code. Please
look up SONY’s codes in your universal remote’s hand book.
• This TV will turn off automatically if there’s no signal present for more than 15
minutes.
To Next Page
Loading...
Need help?
General
