Schaudt LT 100 - Monitoring Water and Waste Water Tank Levels; LT 100 Troubleshooting, Alarms, and Faults

Operating Instructions Operator and control panel LT 100
6
Date: 19.07.2018 8310068 BA / EN
3.5 Checking tank levels
" Touch Check tank level sensor:
-- W a t e r o r
-- Waste water
F The level of the relevant tank is displayed:
-- Water: 100%, 75%, 50%, 25%;
The tank is empty if the 25% LED flashes.
-- Waste water: 100%, 75%, 50%, 25%
The tank is full if the 100% LED flashes.
3.6 Troubleshooting and remedies
3.6.1 Alarms
Y ATTENTION!
Total discharge results in damage to the leisure area battery:
F A low battery charge, indicated by low voltage, must be prevented.
F Check the voltage regularly (see Section 3.4)
Y It is best to carry out checks in the morning before 12V consumers are
switched on.
Alarm Possible cause Remedy
Totally discharge of the lei-
sure area battery.
Voltage of the leisure bat-
tery has fallen below
11.0
V
.
Switch off all 12V consu-
mers.
1
1
.
0
V
.
Charge the battery
immediately:
-- Start engine
(motorhomes only)
12V supply cannot
switched on.
or
-- connect to 230V power
supply