Scheppach AC10/8V - Page 40

www.scheppach.com · service@scheppach.com www.scheppach.com · service@scheppach.com
Mode Yellow light Green light Light blue light
Bicycle mode < 30 psi 30-50 psi
Motorcycle mode < 2 bar 2-3 bar
Car mode < 2 bar 2-3 bar
Ball mode < 4 psi 6-16 psi
Manual mode Continuous
10.3 Setting the pressure (Fig. 1)
ATTENTION! If the measured pressure is higher than the maximum value that is pre-set in the selected more, the light
illuminates red.
The pressure can also be regulated using the “+” (14) and “-” (13) buttons.
The “+” button can be used to increase the pressure.
The “-” button can be used to decrease the pressure.
10.4 Inating (Fig. 1)
• Press the On/O󰀨 switch on the pump (9) to start the ination process.
• The pump stops automatically as soon as the pre-set pressure is reached.
• It can also be stopped by pressing the On/O󰀨 button on the pump (9) again.
• After inating, rst remove the adapter (19, 20, 21) from the compressed air hose and then pull the compressed air
hose (16) o󰀨 the device.
10.5 LED work lamp (Fig. 1)
This product is equipped with an LED work lamp to illuminate the immediate work area and improve visibility in poorly lit
environments.
CAUTION! Do not look directly into the LED work lamp or the light source.
1 Press the LED button (12) again for a short time to switch the LED work light on.
2 Pressing again causes the light to ash in SOS mode.
3 Pressing a third time switches the light o󰀨 again (the LED work light can also be used when the device is switched o󰀨).