EasyManua.ls Logo

Scheppach HC51Si - User Manual

Scheppach HC51Si
104 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Nachdrucke, auch auszugsweise, bedürfen der Genehmigung.
Technische Änderungen vorbehalten. Abbildungen beispielhaft!
Art.Nr.
5906141901
AusgabeNr.
5906141901_0202
Rev.Nr.
19/08/2021
DE
Kompressor
Originalbedienungsanleitung
5
GB
Compressor
Translation of original instruction manual
19
CZ
Kompresor
Překlad originálního návodu k obsluze
30
SK
Kompresor
Preklad originálneho návodu na obsluhu
41
HU
Kompresszor
Eredeti használati utasítás fordítása
52
PL
Kompresor
Tłumaczenie oryginalnej instrukcji obsługi
63
HR
Kompresor
Prijevod originalnog priručnika za uporabu
75
SI
Kompresor
Prevod originalnih navodil za uporabo
86
HC51Si

Table of Contents

Other manuals for Scheppach HC51Si

Preview: Original Instruction Manual
Original Instruction Manual96 pages

Questions and Answers

  • S
    Sarah RoseJul 29, 2025
    What to do if my Scheppach HC51Si tools do not start?
    • M
      mallorylunaJul 29, 2025
      If your Scheppach Air Compressor starts, and the pressure gauge shows pressure, but your tools aren't working, it could be due to several reasons. First, the compressed air hose and tools may have a leak and need replacement. Also, the pressure regulator might be set too low; try increasing the pressure using the regulator. Finally, a quick coupling could be leaking, in which case you should contact your local service center and only allow qualified personnel to carry out repairs.
  • W
    william97Aug 7, 2025
    Why does my Scheppach HC51Si not start?
    • P
      Peter DunnAug 7, 2025
      If your Scheppach Air Compressor doesn't start, several factors could be at play. First, check the cable, mains plug, fuse, and socket to ensure mains voltage is available. If the mains voltage is too low, ensure the extension cable isn't too long and has adequately sized wires. Also, the compressor may not operate if the outside temperature is below +5 °C. Lastly, the motor might be overheated; allow it to cool down, and address the cause of overheating if necessary.
  • C
    Carolyn PowersAug 19, 2025
    What to do if my Scheppach Air Compressor starts but there is no pressure?
    • W
      William BautistaSep 12, 2025
      If your Scheppach Air Compressor starts but isn't building pressure, it could be due to a few issues. The safety valve might be leaking, in which case you should contact your local service center and only allow qualified personnel to carry out repairs. Damaged seals could also be the cause; inspect them and have any damaged ones replaced by a service center. Lastly, check the drain screw for condensation; tighten it by hand and replace the seal if needed.

Summary

Explanation of Device Symbols

Safety and Warning Symbols

Symbols indicating safety precautions, hazards, and operational warnings.

Technical and Environmental Symbols

Symbols related to sound levels and environmental conditions.

1. Introduction and Device Overview

Manufacturer & Manual Guidance

Details about the manufacturer and advice on using the manual.

Key Components and Scope of Delivery

Identifies compressor parts and lists items included in the package.

4. Proper Use and Safety

Intended Use & Operating Environment

Defines the compressor's proper application and required operating conditions.

General Safety Guidelines

Covers fundamental safety measures for operation and personal protection.

5. Safety Information Continued

Tool Maintenance & Operational Safety

Guidelines for tool maintenance, cable safety, and operational practices.

Noise, Specific Usage Safety & Additional Warnings

Addresses noise, specific application safety, and additional precautions.

Hazardous Areas & Pressure Vessel Operation

Hazardous Areas & Pressure Vessel Maintenance

Safety for hazardous areas and procedures for pressure vessel care.

6. Residual Risks & 7. Technical Data

Risk Mitigation & Key Specifications

Discusses risk mitigation and lists essential technical specifications.

8. Unpacking & 9. Before Commissioning

Unpacking, Checks & Setup

Steps for unpacking, damage checks, and initial setup guidelines.

Child Safety & Installation Location

Child safety warning and requirements for installation location.

10. Attachment & Operation

Assembly, Power & Controls

Instructions for assembly, power connection, and operating controls.

11. Electrical Connection

Compliance, Cable Safety & AC Motor

Electrical compliance, cable care, and AC motor specifications.

12. Cleaning, Maintenance & Storage

Maintenance Safety & Component Care

Safety for maintenance, cleaning procedures, and care for components.

Electrical Repairs & Storage Advice

Requirements for electrical repairs and secure storage of the compressor.

13. Transport & 14. Disposal

Transport Safety & Environmental Disposal

Guidance on safe transport and environmental disposal of the device.

15. Troubleshooting

Compressor Operational Faults

Common issues like not starting or no pressure, with remedies.

Tool Performance Issues

Troubleshooting when tools do not operate despite adequate pressure.

CE Declaration of Conformity

Product Identification & Compliance Standards

Identifies the product and its conformity to EU directives, standards, and RoHS.

Warranty Information by Region

Warranty Terms for Major Regions

Summarizes warranty terms for Germany, Britain, and Eastern European countries.

Scheppach HC51Si Specifications

General IconGeneral
Handle(s)Yes
Product colorBlack, Blue
Housing material-
Number of wheels2 wheel(s)
Noise level60 dB
Intake capacity- l/min
Air tank capacity50 L
Maximum operating pressure8 bar
Motor power1500 W
Power sourceAC
AC input voltage230 V
AC input frequency50 Hz
Weight and Dimensions IconWeight and Dimensions
Depth740 mm
Width330 mm
Height650 mm
Weight30000 g

Related product manuals