Scheppach HC51Si User Manual

www.scheppach.com
GB
|
29
15. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
The compressor does
not start.
Mains voltage is not available.
Check the cable, mains plug, fuse and
socket.
Mains voltage is too low.
Make sure that the extension cable is not
too long. Use an extension cable with
large enough wires.
Outside temperature is too low.
Never operate with an outside temperature
of below +5 °C.
Motor is overheated.
Allow the motor to cool down. If
necessary, remedy the cause of the
overheating.
The compressor
starts but there is no
pressure.
The safety valve leaks.
Contact your local service centre. Only
allow qualied personnel to carry out
repairs.
The seals are damaged.
Check the seals and have any damaged
seals replaced by a service centre.
The drain screw for condensate
leaks.
Tighten the screw by hand. Check the seal
on the screw and replace if necessary.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools do
not start.
The hose connections have a leak.
Check the compressed air hose and tools
and replace if necessary.
A quick coupling has a leak.
Contact your local service centre. Only
allow qualied personnel to carry out
repairs.
Insu󰀩cient pressure set on the
pressure regulator.
Increase the set pressure with the
pressure regulator.

Scheppach HC51Si Specifications

General

Handle(s)	Yes
Product color	Black, Blue
Housing material	-
Number of wheels	2 wheel(s)
Noise level	60 dB
Intake capacity	- l/min
Air tank capacity	50 L
Maximum operating pressure	8 bar
Motor power	1500 W
Power source	AC
AC input voltage	230 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	740 mm
Width	330 mm
Height	650 mm
Weight	30000 g