30
|
GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
By properly disposing of this product, you
are also contributing to the eective use of
natural resources. You can obtain informa-
tion on collection points for waste equip-
ment from your municipal administration,
public waste disposal authority, an author-
ised body for the disposal of waste electri-
cal and electronic equipment or your waste
disposal company.
13. Troubleshooting
Fault Possible cause Remedy
The compressor does
not start.
• No supply voltage.
• Insucient supply voltage.
• Outside temperature is too
low.
• Motor is overheated.
• Check cable, power plug, fuse
and socket.
• Avoid extension cables that are
too long. Use extension cables
with sucient wire cross-sec-
tion.
• Do not operate below +5° C
outside temperature.
• Allow the motor to cool down. If
necessary, eliminate the cause
of overheating.
The compressor
starts but there is no
pressure.
• The non-return valve leaks.
• The seals are damaged.
• Replace non-return valve.
• Check seals, have broken
seals replaced at a specialist
workshop.
The compressor starts,
pressure is shown on
the pressure gauge,
but the tools do not
start.
• The hose connections
have a leak.
• A quick-lock coupling has
a leak.
• Check compressed air hose
and tools, replace if necessary.
• Check quick coupling, replace if
necessary.
To Next Page
Loading...
Need help?
General
