www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
22
|
GB
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
2. Device description (g. 1-2)
1. Machine foot
2. Column
3. Clamping handle
4. Drilling table
5. Motor
6. Speed adjustment lever (handle)
7. V-belt cover
8. Digital display
9. On and off switch
10. Handle
11. Folding swarf protector
12. Drill chuck (illustration may differ)
13. Machine head
14. On and off switch laser
15. Depth indicator with stop
16. Crank handle
17. Hexagonal screw
A. Allen wrench 4 mm
B. Allen wrench 3 mm
C. Battery
3. Scope of delivery
• Machine foot 1x
• Column 1x
• Clamping handle 1x
• Drilling table 1x
• Speed adjustment lever (handle) 1x
• Handle 3x
• Folding swarf protector 1x
• Drill chuck 1x
• Machine head 1x
• Crank handle 1x
• Hexagonal screw 4x
• Battery 2x
• Allen wrench 2x
4. Proper use
The bench drill is designed for drilling in metal, wood,
plastic and tiles. Straight shank drills with a drilling
diameter from 3 mm to 16 mm can be used. The
device is intended to be used by do-it-yourselfers.
It was not designed for heavy commercial use. The
tool is not to be used by persons under the age of 16.
Children over the age of 16 may use the tool except
under supervision. The manufacturer is not liable for
damage caused by an improper use or incorrect op-
eration of this device.
1. Introduction
Manufacturer:
scheppach Fabrikation von
Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
NOTE:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no
liability for damage to the device or caused by the
device arising from:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specied,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions package
with the machine at all times and store it in a plastic
cover to protect it from dirt and moisture. Read the in-
struction manual each time before operating the ma-
chine and carefully follow its information. The machine
can only be operated by persons who were instructed
concerning the operation of the machine and who are
informed about the associated dangers. The minimum
age requirement must be complied with.
In addition to the safety notices contained in this
operating manual and the particular instructions for
your country, the generally recognised technical reg-
ulations for the operation of identical devices must
be complied with.
To Next Page
Loading...
