20 І 40
Troubleshooting
Supposed malfunctions, errors or damages are often caused by events which can be remedied by the operator. Therefore
check the power tool on the basis of the following table before you contact a specialist. Many malfunctions may thus be re-
medied.
Problem Possible cause Approach
1. Power tool does not
start
Power supply interrupted Check power supply by connecting another power tool
Power cord or plug defective Have an electrician check the tool
Other electrical defect of the power tool Have an electrician check the tool
2. Power tool does
not operate with full
power
Extension cord too long and/or cross-
section too small
Use extension cord with permissible length and/or
adequate cross-section
Power supply (e.g. generator) voltage
too low
Connect power tool to an appropriate power supply
3. Poor operation
results
Power tool worn out Replace insertion tool
Grinding plate worn out Have grinding plate replaced
4. Considerable dust
formation
Brush edge worn out Have brush edge replaced
Dust extraction not connectred /
switched on
Connect / switch dust extraction
Storage and transport
1. Whenever you do not use the power tool, you must
keep it in a dry and weil ventilated place out of the
reach of children, e.g. on a high cabinet or in a
closed place.
2. Keep power tool, instruction manual and accesso-
ry parts, if any, together in the original packaging,
if possible. Thus you have all information and parts
available at any time.
3. Always hold the power tool by its handle.
4. To avoid transport damages, you must pack the po-
wer tool or use the original packaging.
5. Protect the power tool against vibrations and shock,
especially during transport in vehicles.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
