www.scheppach.com
26
|
GB
15. Maintenance
Caution! Pull out power plug.
• Replace worn out cutting discs.
• Replace damaged protection device
•
with a piece of cloth or brush.
• All moveable parts must be re-lubricated at period-
ic intervals.
•
• The tub (4) and coolant pump (13) must be cleaned
the pipe or the cooling of the diamond cutting disc
(10) is not guaranteed.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: cutting wheel, carbon brush, table & cut-
ting head guides
Spare parts
parts:
•
• Article No. of device
• Ident. No. of device
• Spare Part No. of the required spare part
16. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be re-
-
material, such as metal and plastic. Defec-
tive components must be disposed of as special
Old devices must not be disposed of with house-
hold waste!
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
and electronic equipment.
•
operational readiness.
• Press the red Test button. This action simulates a
leakage current.
• -
er will disconnect the load from the mains. This is
•
• The Reset button must be pressed a second time
for operation.
• The load can now be inserted.
Technical data:
Triggering leakage current: < 30 mA
Number of pins: 2-pin wired
Dimensions: 126 x 50 x 88 mm
USE ACCORDING TO MANUFACTURER‘S
INSTRUCTIONS!
The portable leakage current circuit-breaker is de-
signed for wet grinding machines and similar elec-
trical loads in the household.
-
-
and sudden restart of the machine after restoration
of power.
-
age current circuit-breaker installed.
12. Cleaning
Caution! Pull out power plug.
13. Transport
Attention! Pull out the power plug
To transport the machine, position the machine head
place.
14. Storage
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from
dust and moisture. Store the operating manual with
the electrical tool.
To Next Page
Loading...
Need help?
General
