What to do if my Scheppach Log Splitter fails to split logs?
If the Scheppach Log Splitter fails to split logs, it might be due to several reasons. First, ensure the log is correctly positioned according to the 'operation' section. The log size might exceed the machine's capacity, so reduce the log size. A blunt wedge cutting edge can also be the cause, so sharpen it. If you notice oil leaks, locate the leak and contact your dealer.
Why is my Scheppach HL760L Log Splitter leaking oil around the cylinder ram?
If you notice oil leaks around the cylinder ram or from other points on your Scheppach Log Splitter, several factors could be responsible. It may be due to air sealed in the hydraulic system, so loosen the bleed screw by some rotations before operating the log splitter. Ensure the bleed screw is tightened before moving the log splitter. Also, check if the oil drain screw is loose and tighten it firmly. If the hydraulic control valve assembly and/or seal is worn, contact your dealer.
General| Power | 2200 W |
|---|---|
| Splitting Force | 7 tons |
| Max Log Length | 520 mm |
| Max Log Diameter | 250 mm |
| Voltage | 230 V |
| Hydraulic Oil Capacity | 3.5 L |
To Next Page
