What to do if my Scheppach HL760LS fails to split logs?
If your Scheppach Log Splitter fails to split logs, consider the following: * Ensure the log is positioned correctly, referring to the 'operation' section for proper log loading techniques. * Reduce the log size if it exceeds the machine's capacity. * Sharpen the wedge cutting edge if it's blunt. * If you notice oil leaks, locate the source and contact your dealer for assistance.
What to do if there are oil leaks around the cylinder ram of my Scheppach HL760LS Log Splitter?
If you notice oil leaks around the cylinder ram or from other points on your Scheppach Log Splitter: * Loosen the bleed screw by a few rotations before operating the log splitter to release any air sealed in the hydraulic system. * Ensure the bleed screw is tightened before moving the log splitter. * Check and firmly tighten the oil drain screw if it's loose. * If the hydraulic control valve assembly and/or seals are worn, contact your dealer for assistance.
Why does my Scheppach Log Splitter log pusher move jerkily?
If the log pusher on your Scheppach Log Splitter moves jerkily, makes unfamiliar noises, or vibrates a lot, it could be due to a lack of hydraulic oil and excessive air in the hydraulic system. Check the oil level and refill if necessary. Contact your dealer for further assistance.
What to do if Scheppach HL760LS Log Splitter fails to split logs?
If your Scheppach Log Splitter isn't splitting logs, several factors could be the cause. First, ensure the log is correctly positioned. If the log size exceeds the machine's capacity, reduce its size. A blunt wedge cutting edge will also cause this issue, so sharpen it. Finally, check for oil leaks, and if found, contact your dealer.
Why is my Scheppach Log Splitter log pusher moving jerkily?
If the log pusher on your Scheppach Log Splitter is moving jerkily, accompanied by unusual noises or excessive vibration, it may be due to a lack of hydraulic oil or excess air in the hydraulic system. Check the oil level and refill if necessary. It is also recommended to contact your dealer.
What to do if there are oil leaks around the cylinder ram of Scheppach HL760LS Log Splitter?
If you notice oil leaks around the cylinder ram or other points on your Scheppach Log Splitter, it could be due to several reasons. It may be caused by air sealed in the hydraulic system, in which case you should loosen the bleed screw by a few rotations before operating the log splitter. Ensure the bleed screw is tightened before moving the log splitter. Also, check if the oil drain screw is loose and tighten it firmly. If the hydraulic control valve assembly and/or seals are worn, contact your dealer.
Step-by-step guide to assembling the base frame, handle, guards, and tray tables.
Proper log splitting, hoist limiting, and handling of jammed logs.
Diagnosing and resolving common problems encountered with the log splitter.
General| Product type | Electric log splitter |
|---|---|
| Product color | Blue, Grey |
| Housing material | - |
| Maximum pressure | 7 t |
| Transport wheels | Yes |
| Maximum log length | 520 mm |
| Maximum log diameter | 250 mm |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 Hz |
Weight and Dimensions| Depth | 950 mm |
|---|---|
| Width | 330 mm |
| Height | 510 mm |
| Weight | 63000 g |
To Next Page
