To Next PageTo Next PageWhat to do if the Scheppach Log Splitter hydraulic pump does not start?
If the hydraulic pump of your Scheppach Log Splitter doesn't start, there could be a couple of reasons. First, check the cable to ensure there is electric power. Second, the thermal switch of the motor may have cut off; in this case, engage the thermal switch inside the motor casing again.
Why does the column on my Scheppach HL730 Log Splitter not move down?
If the column on your Scheppach Log Splitter isn't moving down, it might be due to a few reasons. First, check the oil level and refill if it's low. Second, make sure all levers are properly connected and fixed. Finally, dirt in the rails could be the culprit, so clean the column.
What to do if the motor starts but the column does not move down on my Scheppach HL730 Log Splitter?
If the motor of your Scheppach Log Splitter starts but the column doesn't move down, it may be due to the wrong turning direction of the motor. Check the turning direction and change it if necessary.
What to do if the Scheppach HL730 motor starts but the column doesn't move down?
If the motor starts but the column does not move down, the issue might be the wrong turning direction of the motor. To resolve this, check the turning direction of the motor and change it.
What to do if the thermal switch of the Scheppach HL730 motor cuts off again?
If the thermal switch of the motor cuts off again, it could be due to a low oil level. Check the oil level and refill as needed.
How to fix a Scheppach HL730 Log Splitter column that does not move down?
If the column does not move down, it could be caused by dirt in the rails. Clean the column to resolve this issue.
What to do if the Scheppach HL730 column does not move down?
If the column does not move down, one of the levers might not be connected. Check the fixing of the lever.
General| AC input voltage | 230 V |
|---|---|
| AC input frequency | 50 Hz |
| Product type | Electric log splitter |
| Product color | Black, Blue |
| Maximum pressure | 7 t |
| Maximum log length | 550 mm |
| Maximum log diameter | 300 mm |
Weight and Dimensions| Depth | 850 mm |
|---|---|
| Width | 915 mm |
| Height | 1495 mm |
| Weight | 98500 g |
Key safety symbols for operation and personal protection.
Symbols related to safe handling, maintenance, and workspace.
Essential safety guidelines for operating electric machines.
Prohibition of removing or disabling safety features.
Troubleshooting steps for when the hydraulic pump fails to operate.
Solutions for issues with the splitting column's downward movement.
