Scheppach HL730 User Manual

www.scheppach.com
30
|
GB
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
 Possible cause 
The hydraulic pump does
not start
No electric power
Check cable for electric power
Thermal switch of motor cut o󰀨
Engage thermal switch inside the motor
casing again
The column does not
move down
Low oil level Check oil level and rell
One of the levers not connected Check xing of lever
Dirt in the rails Clean the column
Motor starts but column
does not move down
Wrong turning direction of 3-phase
motor
Check turning direction of motor and
change

Scheppach HL730 Specifications

General

AC input voltage	230 V
AC input frequency	50 Hz
Product type	Electric log splitter
Product color	Black, Blue
Maximum pressure	7 t
Maximum log length	550 mm
Maximum log diameter	300 mm

Weight and Dimensions

Depth	850 mm
Width	915 mm
Height	1495 mm
Weight	98500 g