What to do if Scheppach HL460 Log Splitter fails to split logs?
If your Scheppach Log Splitter isn't splitting logs, here are a few potential causes and solutions: * **Improperly positioned log:** Make sure you are loading logs correctly. * **Oversized log:** Reduce the log size to fit within the machine's capacity. * **Blunt wedge:** Sharpen the cutting edge of the wedge. * **Oil leaks:** Locate the leak(s) and contact your dealer.
What to do if Scheppach Log Splitter has oil leaks around the cylinder ram?
If you notice oil leaks around the cylinder ram or from other points on your Scheppach Log Splitter, consider these potential causes and solutions: * **Air sealed in hydraulic system:** Loosen the bleed screw a few rotations before operating the log splitter. * **Loose bleed screw:** Ensure the bleed screw is tightened before moving the log splitter. * **Loose oil drain screw:** Tighten the oil drain screw firmly. * **Worn valve assembly/seals:** Contact your dealer.
Why does Scheppach HL460 log pusher move jerkily?
If the log pusher on your Scheppach Log Splitter moves jerkily, makes unfamiliar noises, or vibrates excessively, it may be due to a lack of hydraulic oil or excessive air in the hydraulic system. Check the oil level and refill if necessary. Contact your dealer for assistance.
What to do if my Scheppach HL460 fails to split logs?
If your Scheppach Log Splitter isn't splitting logs, several factors could be at play. First, ensure the log is correctly positioned as described in the 'operation' section. The log size might exceed the machine's capacity, so reduce the log size if needed. A dull wedge cutting edge can also be the culprit, so try sharpening it. Finally, check for oil leaks; if you find any, contact your dealer.
Why is oil leaking from my Scheppach HL460 Log Splitter around the cylinder ram?
Oil leaks around the cylinder ram or from other points in your Scheppach Log Splitter can occur for several reasons. Air might be sealed in the hydraulic system; loosen the bleed screw a few rotations before operating the log splitter. Ensure the bleed screw is tightened before moving the log splitter. Also, check if the oil drain screw is loose and tighten it firmly. If the hydraulic control valve assembly and/or seals are worn, contact your dealer.
What to do if the log pusher on my Scheppach HL460 Log Splitter moves jerkily?
If the log pusher on your Scheppach Log Splitter is moving jerkily, making unfamiliar noises, or vibrating excessively, it may be due to a lack of hydraulic oil or excess air in the hydraulic system. Check the oil level and refill if necessary. You may also need to contact your dealer for further assistance.
Why does my Scheppach HL460 Log Splitter motor stop starting?
The motor of your Scheppach Log Splitter might stop starting because the overload protection device has disengaged to protect it from damage. Contact a qualified electrician for assistance.
Provides critical safety warnings and instructions for operating electric machines safely.
Details additional safety points, remaining hazards, and warnings about electromagnetic fields.
Covers initial setup, assembly checks, and maintaining the correct hydraulic oil level.
Details on the ventilation screw and the correct procedure for splitting logs.
How to limit hoist and ensure logs are placed correctly to prevent damage and accidents.
Procedures for handling jammed logs and ensuring safe electrical connections.
Identifies common problems like motor failure, splitting issues, and oil leaks with their causes and remedies.
General| Splitting Force | 4 tons |
|---|---|
| Hydraulic Oil Capacity | 5 L |
| Weight | 70 kg |
| Motor Power | 2.2 kW |
| Voltage | 230 V |
| Power | 2200 W |
To Next Page