Scheppach HL460 User Manual

www.scheppach.com
32
|
GB
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
Problem Possible Cause Remedy
Motor stops starting
Overload protection device
disengaged to protect the log
splitter from being damaged
Contact a qualied Electrician.
Fails to split logs
Log is improperly positioned Refer to ”operation” section to perfect log loading
Size of log exceeds the
capacity of the machine
Reduce log size before operating
Wedge cutting edge is blunt Sharpen cutting edge
Oil leaks Locate leak(s) and contact your dealer
Log pusher moves
jerkily, taking
unfamiliar noise or
vibrating a lot
Lack of hydraulic oil and
excessive air in the hydraulic
system
Check oil level for possible relling. Contact your
dealer
Oil leaks around the
cylinder ram or from
other points
Air sealed in hydraulic system
while operating
Loosen bleed screw by some rotations before
operating the log splitter
Bleed screw is not tightened
before moving the log splitter
Tighten bleed screw up before moving the log
splitter
Oil drain screw loose Tighten the oil drain screw rmly
Hydraulic control valve
assembly and/or seal(s) worn
Contact your dealer

Scheppach HL460 Specifications

General

Brand	Scheppach
Model	HL460
Category	Log Splitter
Language	English