Scheppach HM210L - EU Declaration of Conformity; Troubleshooting

17 Troubleshooting
Fault Possible cause Remedy
Motor does not work Engine, cable or connector
defective, mains fuses blown.
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check mains
fuses and replace as necessary
The engine runs slowly and does
not reach the operating speed.
Voltage too low, coils dam-
aged, capacitor burnt.
Have an electrician check the voltage. Arrange for in-
spection of the motor by a specialist. Arrange for re-
placement of the capacitor by a specialist.
Engine producing excessive
noise.
Coils damaged, motor defec-
tive.
Arrange for inspection of the motor by a specialist.
The engine does not reach full
power.
Circuits in the network are
overloaded (lamps, other mo-
tors, etc.).
Do not use any other products or motors on the same
circuit.
Motor overheats easily. Overloading of the motor, in-
sufficient cooling of the motor.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.
Saw cut is rough or wavy. Saw blade dull, tooth shape
not appropriate for the materi-
al thickness.
Resharpen saw blade and/or use suitable saw blade.
Workpiece pulls away and/or
splinters.
Excessive cutting pressure
and/or saw blade not suitable
for use.
Insert suitable saw blade.
18 EU Declaration of Conformity
Translation of the original Declaration of Conformity
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
We declare under our sole responsibility that the product
described here complies with the applicable directives
and standards.
Brand: SCHEPPACH
Art. designation: CROSS-CUT MITRE SAW -
HM210L
Item No. 5901226901
EU directives:
2014/30/EU, 2006/42/EC, 2011/65/EU*
* The object of the declaration described above fulfils the
regulations of the directive 2011/65/EU of the European
Parliament and Council from 8th June 2011, on the re-
striction of the use of certain hazardous substances in
electrical and electronic equipment.
Applied standards:
EN62841-1:2015/A11:2022;
ENIEC62841-3-9:2020/A11:2020;
ENIEC55014-1:2021; ENIEC55014-2:2021;
ENIEC61000-3-2:2019/A1:2021;
ENIEC61000-3-11:2019
Documentation authorised representative:
Matthias Herz
Günzburger Str. 69
D-89335 Ichenhausen
Ichenhausen, 21.06.2024
Simon Schunk
Division Manager Product Center
Andreas Pecher
Head of Project Management
34 | GB www.scheppach.com