www.scheppach.com
GB
|
39
14. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, fuses
burnt
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts up
slowly and does not
reach operating speed.
Voltage too low, coils damaged,
capacitor burnt
Contact the utility provider to check the
voltage. Arrange for inspection of the motor
by a specialist. Arrange for replacement of the
capacitor by a specialist
Motor makes excessive
noise
Coils damaged, motor defective Arrange for inspection of the motor by a
specialist
The motor does not
reach its full power.
Circuits in the network are overload-
ed (lamps, other motors, etc.)
Do not use any other equipment or motors on
the same circuit
Motor overheats easily.
cooling of the motor
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Saw cut is rough or wavy Saw blade dull, tooth shape not ap-
propriate for the material thickness
Re-sharpen saw blade and/or use suitable saw
blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or
saw blade not suitable for use
Insert suitable saw blade
This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper handling
of waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment.
By properly disposing of this product, you are also
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
To Next Page
Loading...
