Scheppach HM254 User Manual

www.scheppach.com
40
|
GB
14. Troubleshooting
Fault Possible cause Remedy
Motor does not work
Motor, cable or plug defective,
fuses burnt
Arrange for inspection of the machine by a special-
ist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts
up slowly and does
not reach operating
speed.
Voltage too low, coils damaged,
capacitor burnt
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by a
specialist
Motor makes exces-
sive noise
Coils damaged, motor defective Arrange for inspection of the motor by a specialist
The motor does not
reach its full power.
Circuits in the network are over-
loaded (lamps, other motors, etc.)
Do not use any other equipment or motors on the
same circuit
Motor overheats
easily.
Overloading of the motor, insu󰀩-
cient cooling of the motor
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not ap-
propriate for the material thickness
Re-sharpen saw blade and/or use suitable saw
blade
Workpiece pulls
away and/or splin-
ters
Excessive cutting pressure and/or
saw blade not suitable for use
Insert suitable saw blade
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Uni-
on, di󰀨erent regulations may apply to the disposal of
waste electrical and electronic equipment.

Scheppach HM254 Specifications

General

Laser guide	Yes
Product color	Blue, Grey
Sliding rails	-
Number of blade teeth	60
Input power	2000 W
Power source	AC
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Idle speed (max)	- RPM
Cutting width (90°)	340 mm

Weight and Dimensions

Depth	820 mm
Width	480 mm
Height	410 mm
Weight	17560 g