Scheppach HP800S

19
Assembly
For reasons of packing, your machine is not completely as-
sembled.
Attaching the handle
Fixing parts:
2 hexagon bolts M 10 x 65
2 washers 10 mm dia.
2 lock nuts
1 hexagon bolt M 5 x 25
Fold lower and upper handle apart Fig. 2.1
Slide the handle in between the fixing brackets and se-
cure with 2 hexagon bolts M 10 x 65, 2 washers 10 mm,
and 2 lock nuts. Fasten the gas lever with slotted screw
M 5 x 25 to the upper handle. Fig. 2.2
Mounting the wheel base
Fixing parts:
2 hexagon bolts M 10 x 30
2 washers 10 mm dia.
2 lock nuts M 10
Fasten the pre-assembled wheel base to the holding
brackets using 2 hexagon bolts M 10 x 30, 2 washers 10
mm, and 2 lock nuts (Fig. 2.3)
0RQWDĪ
= XZDJL QD SDNRZDQLH PDV]\QD QLH MHVW NRPSOHWQLH
]PRQWRZDQD
0RFRZDQLHXFKZ\WX
&]ĊĞFLPRFXMąFH
ĞUXE\V]HĞFLRNąWQH0[
SRGNáDGNLĞUHGQPP
QDNUĊWNL]DEH]SLHF]DMąFH
ĞUREDV]HĞFLRNąWQD0[
5R]áRĪ\üXFKZ\WJyUQ\LGROQ\5\V
:VXQąüXFKZ\WPLĊG]\ZVSRUQLNLL]DPRFRZDüSU]\XĪ\FLX
ĞUXEV]HĞFLRNąWQ\FK0[SRGNáDGHNPPL
QDNUĊWHN ]DEH]SLHF]DMąF\FK 3U]\PRFRZDü GĨZLJQLĊ JD]X
GRXFKZ\WXJyUQHJRSU]\SRPRF\ZNUĊWX]URZNLHP0[
5\V
0RQWDĪSRGZR]LD
&]ĊĞFLPRFXMąFH
ĞUXE\V]HĞFLRNąWQH0[
SRGNáDGNLRĞUHGQPP
QDNUĊWNL]DEH]SLHF]DMąFH0
3U]\WZLHUG]LüF]ĊĞFLRZR]PRQWRZDQHSRGZR]LHGRZVSRUQL-
NyZXĪ\ZDMąFĞUXEV]HĞFLRNąWQ\FK0[SRGNáDGHN
PPLQDNUĊWHN]DEH]SLHF]DMąF\FK
(Rys. 2.3)