www.scheppach.com
18
|
GB
14. Troubleshooting
Fault Possible cause Remedy
Stone doesn’t break Blade worn Change knife
Material doesn’t lie at
Stone chips on the
support
Clean the support
Cutting lever won’t
move
Stone chips in moving parts Clean the stone cutter
Turning the upper and lower knives
• When changing the blades, loosen the screws (Fig.
4, Pos. 1) on the upper or lower blade (Fig. 4, Pos. 2)
as required using a Phillips screwdriver.
• Remove the upper or lower blade as required (Fig.
4, Pos. 2).
• Turn the removed knife and replace it in the stone
cutter so that an unworn blade edge forms the new
cutting edge.
• Tighten all screws (Fig. 4, Pos. 1) again.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Blade
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
13. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
dierent materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!
To Next Page
Loading...
Need help?
General
