www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
30
|
GB
m WARNING
Never work on or touch conducting parts on the ig-
spark plug boot from the spark plug before starting
described in these Operating Instructions must be
Cleaning
mount. To remove the gras, tip the lawn mower onto
or clean the mower with water as described below:
• Remove the mulch unit / gras box.
• Fit the hose connection to the mower and turn the
tap on. (Fig. 23)
•
seconds. The rotating blade bar throws the water
onto the bottom of the mower and thus cleans it.
•
•
•
m Note!
-
more than 90 degrees. Dirt and grass is easiest to
the grass. Dried on grass and dirt can result in poorer
mowing performance. Check that the grass chute is
-
Do not use aggressive cleaning agents such as cold
cleaner or petroleum ether.
Wheel axles and wheel hubs
•
Blade
-
thorized service workshop. For optimum results it is
recommended that the blade should be inspected
Changing the blade (Fig. 17)
blade replaced.
Wear gloves when replacing the blade in order to pre-
•
• To replace the blade, undo the screw.
-
pings in or on the mower housing, but instead use
suitable tools such as a brush or a hand broom.
are picked up, the inside of both the grass basket (16)
onto the basket handle with the other. Hang in the
basket from the top. Fig. 9
After mowing
•
mower in an enclosed area.
Remove grass, foliage, grease and oil before stor-
the mower.
• Check all the screws and nuts once more before
loose screws.
•
• Pull the spark plug boot to prevent unauthorized
use.
•
source of danger. Petrol fumes can lead to explo-
sions.
• -
• If the lawn mower is not going to be used for an ex-
suction pump.
• Oil and maintain the machine.
9. Maintenance and cleaning
• Regular, careful maintenance is required to guar-
-
chine.
• Make sure that all nuts, bolts and screws are tight-
-
ing condition.
•
•
•
pump (available from DIY shops).
•
•
•
•
•
To Next Page
Loading...
