www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
32
|
GB
•
in.
• -
ing.
• Be sure to clean the entire machine to protect the
paint.
• Store the machine in a well-ventilated place.
Preparing the mower for transportation (Fig. 22)
•
•
remainder of petrol in the tank.
•
• Remove the spark plug boot from the spark plug.
• -
ing.
• Remove the start tension cable (17) from the hook.
Loosen the quick-release lever (5) and fold the up-
per push bar down. Make sure the cables are not
bent during this process.
• -
tween the upper and lower push bars and the en-
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
-
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
-
improper repairs or the use of spare parts that are not
arising from improper repairs. Such work should be
-
parts.
Times of use
Important hint in case of sending the equipment
to a service station:
equipment is sent back free of oil and gas!
Ordering replacement parts
Please quote the following data when ordering re-
placement parts:
•
• Article number of the machine
Spare parts/accessories
Lawn mower blade - Article no.: 7911200617
Service information
Please note that the following parts of this product
-
lowing parts are therefore also required for use as
consumables.
Wear parts*:
belt
10. Storage
• Never store the mower (with petrol in the tank) in-
side a building in which petrol fumes could come
•
mower in an enclosed area.
• -
haust and the area around the fuel tank free from
grass, leaves and leaking grease (oil).
Preparing the mower for long-term storage
•
•
petrol has been used up.
•
so, remove the used engine oil from a warm engine
To Next Page
Loading...
