www.scheppach.com service@scheppach.com +(49)-08223-4002-99 +(49)-08223-4002-58 www.scheppach.com service@scheppach.com +(49)-08223-4002-99 +(49)-08223-4002-58
GB
|
43
We cannot give exact details about the duration of
use in this case because it is dierent for each indi-
vidual.
The following factors can inuence the condition:
• Circulatory problems in the user’s hands
• Low outside temperatures
• Extended periods of use
We therefore recommend you wear warm work gloves
and take regular breaks.
7. Before rst use
Times of use
Please comply with statutory regulations, which may
vary from location to location.
Make sure that you are familiar with the controls and
operation of the machine. In particular, the user must
know how the work tools and engine can be stopped
quickly.
The machine must only be used by persons who have
read the instruction manual and are familiar with op-
eration of the machine. The user should seek expert
and practical instruction prior to initial operation. The
user must receive instruction on safe use of the ma-
chine from the vendor or another expert.
During this instruction, the user should be made
aware
• that the utmost care and concentration are required
for working with the machine.
• that a ride-on mower which is sliding down a slope
cannot be brought under control by applying the
brake.
The main causes for the loss of control over the ride-
on mower include:
• inadequate adhesion of the wheels,
• driving too fast,
• inappropriate braking,
• incorrect use (sport events, etc.),
• inadequate knowledge of the eects associated
with ground conditions, especially on slopes (see
section „For your safety“, „Working on slopes“),
• incorrect attachment of loads and poor load distri-
bution.
Check the fuel system (particularly visible parts such
as e.g. tank, tank cap, hose connections) before
operating the machine. In the event of any leaks or
damage, do not start the engine – re hazard! Have
the machine repaired by a specialist dealer prior to
operation.
Defective and all other worn or damaged parts must
be removed before using the machine. Replace any
illegible or damaged danger signs and warnings on
the machine.
The screwed-on discharge port (discharge chute on
mowing deck) must always be securely fastened to
the mowing deck. It must not be damaged and, if nec-
essary, it must be replaced by a technician.
The braking function must be checked before each
use.
Before each use, check whether:
• the cutting tool and the entire cutting unit (mow-
ing blade, blade clutch, blade brake, retaining pin,
mowing deck housing) are in good condition. Par-
ticularly check for secure fastening, damage and
wear.
• the tank cap is securely attached.
• the tank and fuel-carrying parts, as well as the tank
cap are in good condition.
• the safety devices are in good condition and func-
tion correctly.
• the tyres (ination pressure, damage, wear) and
frame are in good condition. Check that all screw
connections are securely fastened. In particular, all
maintenance operations listed in the maintenance
schedule under the heading “Before each use”
must be carried out.
If necessary, consult a specialist dealer.
Preparing the area to be mowed
Before mowing, carefully examine the area. Remove
stones, sticks, bones, wires, toys and other objects
that may be ejected.
Ensure that no other people are present on the sur-
face to be mowed
Montage
Some parts of the mower come disassembled. For
quick and easy assembly, read and follow the instruc-
tions below.
Important!
You will need the following additional tools (not sup-
plied) for assembly, and also for maintenance work:
• A 1 liter measuring jug (oil/petrol resistant)
• A petrol can (5 liters is sucient for approx. 6 op-
erating hours)
• A funnel (suitable for the tankʼs petrol ller neck)
• Household wipes (to wipe up oil/petrol residue; dis-
pose of these at a lling station)
• A petrol suction pump (plastic, available from DIY
stores)
• 0,6 liter of engine oil (SAE 30)
• Small hammer
To Next Page
Loading...
Need help?
General
