www.scheppach.com service@scheppach.com +(49)-08223-4002-99 +(49)-08223-4002-58
25 І 52
XIII. Cleaning
m Attention!
Always pull out the mains power plug before starting
any cleaning work.
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device immedi-
ately each time you have nished using it.
• Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep into
the device.
XIV. Disposal and recycling
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Never
place defective equipment in your household refuse.
The equipment should be taken to a suitable collec-
tion center for proper disposal. If you do not know the
whereabouts of such a collection point, you should
ask in your local council ofces.
GB
XII. Trouble shooting
Trouble Probable cause Solution
Cut-Off saw will not start 1. Tool not plugged in
2. Tripped circuit breaker or blown fuse
3. Power cord damaged
4. Worn or damaged carbon brushes
1. Plug in Cut-Off saw
2. Reset circuit breaker or replace fuse.
3. Have power cord replaced by authorized service center.
4. Replace carbon brushes
Cut-Off saw makes
unsatisfactory cuts
1. Glazed cutting wheel
2. Workpiece incorrectly clamped in vice
1. Replace with a new one.
2. Securely clamp and support workpiece.
Cutting wheel does not
come up to speed
1. Extension cord too light or too long
2. Low voltage from AC power source
1. Replace Cord.
2. Consult certied electrical contractor.
Cut-Off saw vibrates
excessively during cut
1. Saw not mounted securely to work-
bench
2. Damaged Cutting wheel
3. Workpiece incorrectly clamped in vice
1. Tighten all mounting hardware.
2. Replace Cutting wheel.
3. Clamp workpiece securely in vice.
Cut-Off saw does not
make accurate cuts
1. Fence improperly adjusted
2. Cutting wheel not square to fence
3. Excessive force used to make cut
4. Workpiece moving
1. Inspect and adjust fence.
2. Inspect and adjust wheel
3. Reduce pressure on cuts - let wheel do cutting.
4. Clamp workpiece securely in vice.
Material moves during
cutting
1. Fence slipping or workpiece incorrectly
clamped
2. Vice not securely clamping workpiece
3. Excessive force used to make cut
1. Tighten fence.
2. Clamp workpiece securely in vice.
3. Reduce pressure on cuts - let wheel do cutting.
To Next Page
Loading...
Need help?
General