Scheppach RoboCut L500 User Manual

GB
|
37
E3
Cutter disc
blocked
• Switch the mower o󰀨.
• Turn the mower upside down and check what is preventing the blades from turning.
• Remove the objects and turn the mower over.
• Place the mower in an area with short grass.
• Then press “START” and “OK”.
E4
Obstacle sensor
trigger not reset
• Contact your specialist dealer.
• Take the mower to a specialist dealer.
E5
The mower was
lifted
• Switch the mower o󰀨.
• Move the mower to an area that is free of obstacles. Press the “START” button and
then the “OK” button.
• If the error message is still displayed, switch o󰀨 the product. Turn the mower upside
down and check if there is anything preventing the front axle from moving.
• Remove all obstacles, turn the mower up the right way again and switch it on. Press
“START” and then “OK”.
E6
Roll-over sensor
was triggered
• Stand the mower upright.
• Press “START” and then “OK”.
E7
Inclination
sensors were
triggered
• Switch the mower o󰀨.
• Move the mower to an area in your lawn with level ground.
• Switch the mower on. Press “START” and then “OK”.
E8
Docking/
recharging
failed
• Check that there is 1 metre of space before and after the charging station, without
obstacles or corners.
• The charging station must be placed on level ground.
• Manually place the mower in the charging station for charging. After the mower is
fully charged, press “START” and then “OK”.
BP
Rechargeable
battery thermal
protection
• Switch the mower o󰀨.
• Move the mower to an area in your lawn with level ground.
• Check the temperature of the rechargeable battery.
• If the temperature is too high, let the rechargeable battery cool down.
• If the temperature is too low, wait until the temperature is higher than 5°C.
• Re-start the mower.
• If the error still occurs, replace the rechargeable battery.
• If the error still occurs, contact your specialist dealer.
EE Error unknown
• Re-start the mower.
• If the error still occurs, contact your specialist dealer.
LOCK
Robotic
lawnmower
locked (PIN
entered
incorrectly too
many times)
• Wait 10 minutes and then enter the PIN again.
• Do not switch the robotic lawnmower o󰀨.
• If the error still occurs, contact your specialist dealer.

Scheppach RoboCut L500 Specifications

General

Brand	Scheppach
Model	RoboCut L500
Category	Lawn Mower
Language	English