Scheppach ROBOCUT XXL900

www.scheppach.com
36
|
GB
E7
Inclination sensors
were triggered
1. Switch the mower o󰀨.
2. Move the mower to an area in your lawn with level ground.
3. Switch the mower on. Press the “START” button and then the “OK” button.
E8
Docking/recharging
failed
1. Check that there is 1 metre of space before and after the charging station, without
obstacles or corners.
2. The charging station must be placed on level ground.
3. Manually place the mower in the charging station for charging. After the mower is
fully charged, press the “START” and then the “OK” button.
E9
The robotic lawn-
mower is stuck
1. Place the robotic lawnmower in an area that is free of obstacles.
2. If the error still occurs, contact your specialist dealer.
E10
Protection of the
battery
1. If the temperature is too high, wait until the temperature has dropped. If the tem-
perature is too low, wait until the temperature is above 5 degrees Celsius.
2. If the error message is still displayed, replace the battery. Re-start the mower.
Press START and then OK.
3. If the error still occurs, contact your specialist dealer.
E11 No boundary signal
1. When the mower is in the working area, check the charging station LED indica-
tor. If it lights up red, make sure that the boundary wires are well connected to
the terminals on the charging station. If the problem persists, check whether the
boundary wires have been cut.
E13
Charging current
too high or too low
1. Check docking area.
2. If the error still occurs, contact your specialist dealer.
EE Error unknown
1. Re-start the mower.
2. If the error still occurs, contact your specialist dealer.
BP
Battery thermal
protection
1. Switch the mower o󰀨.
2. Move the mower to an area in your lawn with level ground.
3. Check the temperature of the battery.
4. If the temperature is too high, let the battery cool down.
5. If the temperature is too low, wait until the temperature is higher than 5°C.
6. Re-start the mower.
7. If the error still occurs, replace the battery.
8. If the error still occurs, contact your specialist dealer.
LOCK
Robotic lawnmower
locked (PIN entered
incorrectly too
many times)
1. Wait 10 minutes and then enter the PIN again.
2. Do not switch the robotic lawnmower o󰀨.
3. If the error still occurs, contact your specialist dealer.