Why does my Scheppach Grinder motor overheat easily?
If your Scheppach Grinder's motor overheats easily, it's likely due to overloading or insufficient cooling. To resolve this, avoid overloading the engine during grinding. Also, make sure to remove dust from the engine to ensure optimum cooling.
Why does my Scheppach Tiger 2500 start slowly?
If the engine of your Scheppach Grinder starts slowly and doesn't reach operating speed, it could be due to several reasons: the voltage might be too low, the coils could be damaged or the capacitor might be burnt. In this case, have the power supply company check the voltage and have the engine and capacitor checked or replaced by a specialist.
What to do if Scheppach Tiger 2500 Grinder engine does not run?
If the engine of your Scheppach Grinder does not run, the engine, cable, or connector might be defective, or the fuses could be burnt. Have the machine checked by a specialist, and never attempt to repair the engine yourself. Check the fuses and replace them if necessary.
Procedures for checking the device upon delivery and ensuring completeness.
Importance of using manufacturer's original parts for accessories and spares.
Advice to read and understand the operating instructions before use.
Information and requirements for safe machine operation.
Guidelines for ensuring the machine's stable and safe placement.
Steps for assembling the grinding stone and water tank.
Proper placement and initial setup for stable operation.
Guidelines for connecting the machine to the mains supply and ensuring compliance.
Risks and checks for damaged electrical connection lines.
Details on the motor's voltage, frequency, and extension cable requirements.
Guidelines on the machine's design purpose and safe operational practices.
Identifying potential hazards and minimizing risks during operation.
Advice on grinding direction, water reservoir, and stone condition.
How to set angles and perform effective grinding operations.
Detailed steps for sharpening tools using the leather disc and abrasive paste.
Accessories for stone conditioning and specialized tool grinding.
Items for final sharpening and essential replacement parts.
Visual representation of the motor and wire box electrical connections.
Statement of compliance with EU directives and product standards.
Legal warranty conditions and exclusions for the product.
General| Input power | 200 W |
|---|---|
| Power source | AC |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Idle speed (max) | - RPM |
| Multi-tool applications | Grinding |
Weight and Dimensions| Depth | 320 mm |
|---|---|
| Width | 325 mm |
| Height | 335 mm |
To Next Page
