Need help?Do you have a question about the Schertler Giulia and is the answer not in the manual?
Avoid water, ensure ventilation, and keep away from heat sources to prevent damage and ensure safe operation.
Ensure proper plug/grounding and protect power cords from damage for electrical safety.
Use only specified accessories, exercise caution with carts, and refer servicing to qualified personnel.
Details the GIULIA amplifier's design for musicians and sound engineers, highlighting its compact size, high-quality components, and output options.
Explains the flexible input channel, DI and Line Out connections, and the use of the Insert for external devices like compressors or pedals.
Details the MIC/JACK input, 10V phantom power for electret mics, and 48V phantom power for condenser mics.
Covers the GAIN preamplifier, HIGH/MID/LOW frequency controls, and the WARM low-pass filter for tonal shaping.
Explains the REVERB rotary control for digital reverb level and the VOLUME control for channel volume.
Details the LINE OUT, INSERT, and DI-OUT connections for external system integration.
Identifies the system's main ON/OFF switch located on the rear panel for controlling power.
Details the connection to the mains power supply, specifying voltage requirements (230V~/115V~) and the need for the original cable.
Provides crucial safety advice including handling liquids, avoiding heat sources, using correct voltage, and proper cable replacement.
Describes the GIULIA as a two-way, bass reflex amplified speaker system.
Details the enclosure construction (Plywood), weight (6.3 kg), and dimensions (27 x 18 x 28 cm).
Provides technical specifications for the amplified speaker, including frequency response, sensitivity, and maximum SPL.
Lists technical input specifications for the MIC-IN, including connector type, sensitivity, and impedance.
Details technical output specifications for LINE OUT, DI OUT, and AUX OUT, including connector, level, and impedance.
Specifies technical details for the digital reverb effect, including frequency response, delay time, and reverb time.
Lists the amplifier's components: Woofer, Tweeter, Cross-over, and Amplifier specifications (power, impedance, THD).
To Next Page
General
