10 Recommendations of Lubricants (for all manufactures)
Operating Instructions for Actuators Type AB with Control Unit
OM-ENGLISH-ABCSC.V1.2-16xx-V2.02-2023.04.27
work penetration 0.1 mm: 355 - 430
Dripping temperature: about 200°C
NLGI grade: 00
Acid-free, not or only marginally reacting with water
10.1.2 Application temperature from -50 to +100 °C
Lubricating oil CLP DIN 51517-3
i.e. fully synthetic high-performance industrial gear oil based on poly alpha olefins (PAOs):
Viscosity class: ISO VG 68
Pour point: <-55°C
Compatibility with conventional coatings and sealants
10.1.3 Application temperature from -60 to +100 °C
Lubricating oil CLP DIN 51517-3
i.e. fully synthetic high-performance industrial gear oil based on poly alpha olefins (PAOs):
Viscosity class: min ISO VG 32
Pour point: <-60°C
Compatibility with conventional coatings and sealants
10.2 Spur Gears (actuator size AB8 - AB80)
Lubricating grease DIN 51825 - KPF -1/2 G-20
i.e. High-graphite, bitumen-free permanent lubricant with outstanding EP properties:
Work penetration 0.1mm: 265 - 340.
Observe operating temperature range!
10.3 Output Drive Type A and Spindle Drive (Linear Actuators) plus Failsafe units
Lubricating grease DIN 51825-K(P) R -40
i.e. Water-repellent complex grease based on Al-soap with high resistance to acids and alkalis:
Ambient temperature: -40 to +85 °C
Worked penetration 0,1 mm: 310-340
Dripping point: approximately 260 °C
NLGI-Class: 1
acid-free, not or only slightly reactive with water
Observe operating temperature range!
10.4 Precision Components
Lubricating grease (or spray) DIN 58396- S1
i.e. High-creeping, water-displacing, low-viscosity grease chemically neutral to copper and plastics:
Work penetration 0.1mm: 175 - 385
Dripping temperature: over 150°C
Evaporation loss: max. 1%
Water resistance:
Evaluation grade DIN
51807-1-40
Observe operating temperature range!
26
To Next Page
Loading...
