1 Connect your source to the Magni’s “IN” RCA
jacks with high-quality RCA cables. Or you can
use crappy cables (but why?)
2 Connect the supplied wall-wart cable to the
jack labeled “14VAC.” Do not use any other
wall-wart, or bad things might happen.
3 Optional: Connect the preamp outputs to
powered monitors or an external power amp.
gettIng ConneCted
1
2
3
4
5
4 Turn on the switch. The protection relay will
mute the output for 15-20 seconds, then it will
engage with a click.
5 Select HI or LO gain, depending on your
headphones. IEMs and earbud style headphones
will probably need LO gain. If you don’t have
enough volume control range, use LO gain.
To Next Page
Loading...
