To Next PageTo Next Page
Need help?Do you have a question about the Schiit AEGIR and is the answer not in the manual?
Lists all included accessories and components for the Aegir amplifier.
Outlines essential safety precautions and warnings required for safe device operation.
Connect speakers to the right and left red/black output terminals for stereo use.
Connect source audio using RCA cables to the 'R' and 'L' input jacks.
Connect the power cord and describes the front panel power switch location.
Connect speaker to the two top red terminals for mono use.
Connect a balanced source using an XLR cable for proper mono operation.
Connect the power cord and describes the front panel power switch location.
Covers Standby/Alert and Operate lights indicating device status.
Button to enter or exit standby mode, reducing power draw.
Details heatsink location and importance of adequate ventilation to prevent overheating.
Addresses overheating issues, advising to turn off and cool down the unit.
Explains over-current protection, suggesting checking speaker cables for shorts.
Details DC offset issues and troubleshooting steps involving source disconnection.
General| Type | Stereo Power Amplifier |
|---|---|
| Input Impedance | 22k Ohms |
| Outputs | 5-way binding posts |
| Power Output | 20W RMS per channel into 8 Ohms |
| Gain | 26dB |
| Frequency Response | 20Hz-20kHz |
| THD | <0.01% at 20W RMS, 20Hz-20KHz |
| Inputs | RCA |
| Dimensions | 9 x 13 x 3.875 inches |
