CONTINUITY™
POWER AMPLIFIER
SCH-09K
0A19C2832
115VAC 450W
+
1 and 2 Speaker Outputs. When using Aegir as
a mono amp, connect your speaker to the two
top red terminals only. Right is “+”, and left is “-”.
Please note both of these are active outputs—do
not ground one of them!
3 XLR Input. Connect a balanced source (usually
a preamp) using a high-quality XLR cable. It’s
important that the preamp is truly balanced for
proper operation.
MONO CONNECTION
1 2
3
4
5
4 AC Input. Connect to a wall socket with the
provided AC cord. Or you can use any IEC-type
cord; ours isn’t special.
5 Power Switch. Up is on. Down is off. Pretty
simple. Feel free to leave the amp on all the time
if you’d like.
To Next Page
Loading...
