Commissioning
96
Connecting the
plug-in power
supply
The plug-in power supply supplies the pH meter with low
voltage (7.5 V ... 12 V DC).
Warning
The line voltage on site must lie within the input voltage
range of the original plug-in power supply unit (see section
1.5 T
ECHNICAL DATA).
Caution
Use original plug-in power supplies only
(see section 1.5 T
ECHNICAL DATA).
Note
You can also perform measurements without a plug-in
power supply. However, the functions of the integrated
printer can only be used with connected plug-in power sup-
ply.
1 Insert the plug (1) into the socket (2) of the conductiv-
ity meter.
2 Connect the original SCHOTT plug-in power supply
(3) to an easily accessible mains socket.
1
2
3
To Next Page
Loading...
